AS 4200.2:2017 Pliable building membranes and underlays, Part 2: Installation
Standards Australia
Supersedes: AS/NZS 4200.2:1994 Pliable building membranes and underlays, Part 2: Installation requirements
Draft Designation: DR AS 4200.2:2015The objective of this revision is to specify procedures for the installation of pliable building membranes in buildings that are consistent with good building practice. The requirements for installation have been compiled from a wide range of procedures used in Australia and considered as good practice in the installation of pliable building membranes.
Originated in Australia as part of AS CA22—1965. Previous edition AS/NZS 4200.2:1994. Third edition revised and designated AS 4200.2:2017. Reissued incorporating Amendment No 1 (June 2018). Reissued incorporating Amendment No 2 (June 2021).
Contents:
Section 1: Scope And General
Section 2: Design Specification Requirements
Section 3: Installation Of Pliable Building Membranes
Section 4: Penetrations
Appendix A: Safety Guidance For Pliable Building Membrane Installation
Appendix B: Durability
Appendix C: Protection Against Condensation
Thermal Insulation.
BD-058
Aluminium Foil Insulation Association; Australasian Fire and Emergency Service Authorities Council; Australian Building Codes Board; Australian Cellulose Insulation Manufacturers Association; Australian Professional Thermography Association; Community Energy Network; Consumers Federation of Australia; Council of Textile and Fashion Industries of Australia; CSIRO; Curtin University of Technology; Electrical Regulatory Authorities Council; Housing Industry Association; Insulation Australasia; Insulation Contractors Association of Australia NSW; Insulation Council of Australia and New Zealand; Master Builders Australia; Plastics and Chemicals Industries Association; Pliable Membranes Association of Australia and New Zealand; Polyester Insulation Manufacturers Association; Recessed Luminaire Enclosure Association of Australia.
