Search all content

Specifies requirements and tests for low voltage inverters for the injection of electric power through an electrical installation into the grid at low voltage. This Standard applies to inverters that have power flow in either direction between the energy source and the grid. General requirements relating to the test methods set out in Appendices B to J are specified in Appendix A.

Provides guidance for the siting, installation and operation of radiocommunications facilities for fixed, mobile and broadcasting services operating at frequencies above 30 MHz, which are generically known as the VHF, UHF and SHF bands. This Standard is to be read in conjunction with AS/NZS 5070.1.

Specifies requirements for the design and manufacture of polyethylene storage tanks that are rationally moulded in one-piece seamless construction, for non-buried, vertical installation, and capable of containing water, liquids for food and beverage manufacture and chemical solutions at atmospheric pressure.

Specifies a PAR spectrometric method for the determination of niobium content between 0.005 percent and 1.3 percent in steel. This Standard is technically identical with and reproduced from ISO 9441:1988.

This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee EL-002 - Safety of Household and Similar Electrical Appliances and Small Power Transformers to supersede AS/NZS 60335.2.94:2008 three years from the date of publication of this Standard. During this period AS/NZS 60335.2.94:2008 will also remain current. Regulatory authorities that reference this Standard in regulation may apply these requirements at a different time. Users of this Standard should consult with these authorities to confirm their requirements.

Sets out requirements for preservative-treated wood-based products that require protection against decay, insect or marine borer attack. Keywords: Wood-based products; Wood-based product treatment; Wood-based product protection

AS/NZS 60335.2.40:2019 deals with the safety of electric heat pumps, including sanitary hot water heat pumps, air conditioners, and dehumidifiers incorporating motor-compressors and hydronic fan coils units, their maximum rated voltages being not more than 250 V for single phase appliances and 600 V for all other appliances. Partial units are within the scope of this Standard.

Specifies minimum energy performance requirements for ELV convertor, when tested in accordance with AS/NZS 4870.1.

This Standard sets out the method of determining the impact resistance of flat sheet material.

This Standard sets out the oven-drying method for determining the moisture content of specimens cut from solid timber, and the procedure for sampling of timber lots. This Standard also specifies requirements for the methods of estimating the local moisture content of solid timber using resistance meter and capacitance meter.