Search all content

Sets out requirements for the materials, design and installation of corrugated fibre-reinforced cement roof and wall cladding; provides test procedures for the determination of resistance to wind force; appendix gives advice on the provision of roof ventilation.

Sets out requirements and means of conformance for the design, installation and commissioning of gas installations that are associated with the use or intended use of fuel gases such as natural gas, LP Gas, or biogas.

AS/NZS IEC 60079.10.1:2022 adopts IEC 60079 10 1:2020, which specify requirements for the classification of areas where flammable gas or vapour hazards may arise and may then be used as a basis to support the proper design, construction, operation and maintenance of equipment for use in hazardous areas.

Provides design values of permanent, imposed and other actions to be used in the limit state design of structures and members; intended to be used in conjunction with AS/NZS 1170.0.

Serves as a general introduction to the AS/NZS 1158 series and provides definitions of lighting categories and technical terms essential to the understanding of other Standards in the series especially AS/NZS 1158.1.1, 1158.2, 1158.3.1 and 1158.6.

AS NZS 1158.3.1 2020 specifies performance and design requirements for Category P lighting schemes as described in AS/NZS 1158.0. It also specifies the luminaire data and other data that is needed to facilitate the lighting design and the assessment of conformance to the requirements of this Standard. Street lighting design standard.

AS/NZS 1158.1.1:2022 specifies performance and design requirements for Category V lighting schemes, including requirements relating to the energy efficiency of the luminaires used. It also specifies the luminaire data and other design data that is needed to facilitate the lighting design and the assessment  of conformance to the requirements of this document.

This Standard applies to single-phase or polyphase, air-cooled (natural or forced) portable inverters having a rated supply voltage not exceeding 60 V ripple-free d.c. and an alternating current (a.c.) output where: - the rated output does not exceed 3 kVA; - the rated output voltage is within the range 50 - 500 volt a.c; - the rated frequency of the output is within the range 40 - 100 Hz.

Adopts ISO 13253:2011 to establish test methods for determining the capacity and efficiency ratings of ducted, air-cooled airconditioners and ducted air-to-air heat pumps; residential, commercial and industrial single-package and split-system airconditioners and heat pumps are included.

Sets out methods of testing building facades for environmental loading including water penetration and air infiltration as well as structural tests.