Search all content

Specifies the requirements for damp-proof course and flashing materials of the sheet membrane, strip and collar type for use in building construction.

AS/NZS 3500.3:2025 specifies the requirements for materials, design, installation and testing of roof drainage systems, surface drainage systems and subsoil drainage systems to a point of connection

Sets out requirements for the materials, design and installation of corrugated fibre-reinforced cement roof and wall cladding; provides test procedures for the determination of resistance to wind force; appendix gives advice on the provision of roof ventilation.

Specifies device specifications, functionality, testing and compliance requirements for electrical safety and performance for inverters designed to facilitate connectivity between energy sources and/or energy storage systems and the grid, connected at low voltage. Includes electric vehicles operating in a vehicle to grid mode and stand-alone inverters that are connected to an electrical installation that may be connected to the grid at low voltage. KEYWORDS: inverter, energy storage, grid connection

Serves as a general introduction to the AS/NZS 1158 series and provides definitions of lighting categories and technical terms essential to the understanding of other Standards in the series especially AS/NZS 1158.1.1, 1158.2, 1158.3.1 and 1158.6.

AS NZS 1158.3.1 2020 specifies performance and design requirements for Category P lighting schemes as described in AS/NZS 1158.0. It also specifies the luminaire data and other data that is needed to facilitate the lighting design and the assessment of conformance to the requirements of this Standard. Street lighting design standard.

Sets out the requirements for materials, design, installation and testing of roof drainage systems, surface drainage systems and subsoil drainage systems to a point of connection.

This Standard specifies a test method for determining the particulate emission factor from batch-fed domestic solid fuel burning appliances and the associated particulate emission acceptance criteria.

This Standard specifies a method for the determination of the thickness loss of textile floor coverings under dynamic loading. It is applicable to all types of textile floor coverings with a surface that is level in height and construction. It does not apply to other textile floor coverings unless the areas of different thickness or construction can be tested separately.

This Standard describes a method for determining the strength of the bond between the backing components of a textile floor covering which can be peeled apart. This method is applicable to tufted carpets which have primary and secondary backing materials forming a bonded composite substrate.