Search all content

This Standard sets out the method for testing aggregates to determine the loss of mass due to disintegration when exposed to sodium sulfate solutions over repeated cycles of wetting and drying

The objective of the standard is to provide designers and suppliers with information on the properties of rock sources that may allow the supply of large rock blocks suitable for the protection of sea walls, river banks, dam facings and other structures requiring protection against wave action or erosion caused by flowing water.

Sets out procedures for the preparation, laying and fixing of resilient sheet and tile floor coverings in all forms including flexible PVC, semi-rigid PVC, hybrid modular, linoleum, rubber. Also applies to self-adhesive tiles. Gives details of work necessary to prepare subfloor surfaces, with procedures for laying resilient covering. Does not apply to the laying of synthetic or natural fibre carpet, carpet tiles, timber or cork products. KEYWORDS: sheet; tiles; preparation; laying; fixing

This Standard sets out a method for determining the flakiness index of an aggregate. The Method applies to aggregates having a nominal size not greater than 63.0 mm and having at least 80% by mass retained on a 4.75 mm sieve. The Method makes reference to a particle size distribution procedure which is required for determination of flakiness index.

This Standard sets out the method for the determination of the degradation factor of coarse aggregates. The test categorizes the fines produced by self-abrasion in the presence of water.

AS 1742.13:2023 specifies requirements for the signs, pavement marking and other devices to be applied to commonly used local area traffic management (LATM) schemes

Sets out the method for determining the relative quantity and rate that mixing water will bleed from a sample of freshly mixed concrete under the conditions of the test.

Sets out methods for the sampling, preparation of samples and analysis of dolomite and magnesite refractories and refractory materials.

Provides guidance on the siting and construction of new buildings against aircraft noise intrusion and on the acoustical adequacy of existing buildings in areas near aerodromes. The assessment of potential aircraft noise exposure at a given site is based on the Australian Noise Exposure Forecast (ANEF) system. The Standard also provides guidelines for determining the type of building construction necessary to provide a given noise reduction.

Sets out requirements for the manufacture of pressure equipment as specified in the application Standards AS 1210, AS 1228 and AS 4041. Fabrication, heat treatment, forged construction, cast construction and testing are covered.