Search all content

This Standard sets out the method for determining the percentage of weak particles in coarse aggregates.

Sets out general design and performance requirements and testing procedures for mechanical locksets and latchsets in residential and commercial buildings. Also includes performance requirements for cylinders supplied separately for installation in locksets.

This Standard sets out the method for determining the friction value of a surface using the pendulum friction tester on test specimens prepared from naturally occurring or artificially produced materials which are intended for use as roadway pavement surfacing material.

Presents the objectives and principles of adaptable housing and provides guidelines on planning and design. Adaptable housing is the basis for the development of the accommodation needs of users of all ages and abilities by making provision for future building modifications at minimum cost and disruption to the inhabitants. Includes in Appendix A a checklist for certification of housing units as Adaptable house class A, B or C.

Sets out a flame atomic absorption procedure for the determination of nickel in iron and steel in the range of 0.002 percent to 0.5 percent. The method is technically identical to ISO 4940, Steel and cast iron - Determination of nickel content - Flame atomic absorption spectrometric method.

This Standard is the modified adoption IEC 60849:1998, which applies to sound reinforcement and distribution systems to be used to effect a rapid and orderly mobilization of occupants in an indoor or outdoor area in an emergency situation. It applies to systems using tone signals and to systems with voice announcements for emergency purposes.

This Standard is technically equivalent to and has been reproduced from ISO 10545-14:1995 including Technical Corrigendum 1:1997.

Specifies the requirements for carbon steel and carbon-manganese steel rods, bars, blooms, billets and slabs, delivered in the as-rolled or normalized condition, for forging and for general engineering purposes.

Provides a basis for specifying requirements for aggregates intended for use in the production of concrete, including precast products.

Specifies requirements for the manufacture, grading, finishing and branding of plywood used specifically in formwork, with a maximum length of 3100mm and width of 1500mm, intended to meet off-form surface finish requirements of Classes2, 3, 4 and 5 as specified in AS3610.1.