Search all content

Specifies requirements for the manufacture, grading and finishing of plywood intended for marine use.

Specifies requirements for the design, material and performance of conventional hearing protectors. Also provides guidance on the general requirements for specialist hearing protectors and procedures for the physical and acoustic testing of such devices.

Sets out requirements for an occupational health and safety management system. The requirements may be used for auditing and certification purposes. The requirements follow the guidelines set out in AS/NZS 4804:2001. In this joint revision the terms 'hazard/risk assessment' and 'control of hazards/risks' are used to accommodate the different terminology used in each country to describe similar elements of the systematic management of occupational health and safety.

Sets out specifications for Australian and New Zealand Steel reinforcing materials (bars, coils and welded mesh). Requirements for chemical, mechanical and physical properties for three different strength grades and the three different ductility classes are also covered.

Adopts IEC61439-4, Ed. 1.0 (2012) to provide specific requirements for the design of low-voltage switchgear and controlgear assemblies for use on construction sites.

Specifies an infrared absorption method after combustion of the test portion at high temperature in a current of pure oxygen using a high frequency induction furnace. The method can be used for the determination of sulfur content between 0.002 percent and 0.10 percent in steel. This Standard is identical with and reproduced from ISO 4935:1989.

Specifies requirements for couplers and accessories for scaffolding complying with AS/NZS 1576.3 and AS/NZS 1576.6.

Specifies a flame atomic absorption spectrometric method for the determination of chromium content between 0.002 percent and 2.0 percent in non-alloy and low alloy steel. The procedure involves dissolution of a test portion in acid and determination of the atomic absorption of the chromium spectral line, measured at either 357.9 nm or 425.4 nm in a flame atomic absorption spectrometer. This Standard is identical with and reproduced from ISO 10138:1991.

Specifies classification, labelling and minimum energy performance requirements for ballasts for linear fluorescent lamps for use on 230 V to 250 volt a.c. at 50 Hz supply. This Standard is to be read in conjunction with AS/NZS 4783.1.

The objective of the Standard is to provide materials specifications for steel bars and welded mesh used to reinforce concrete structures that have been designed in accordance with standards such as AS 3600, Concrete structures, or NZS 3101.1, Concrete structures standard, Part 1. This Standard has also been referenced by other design standards.