Search all content

This Standard specifies requirements for testing the durability performance of steel lintels and shelf angles to be built into masonry.

This Standard specifies requirements for connectors and accessories built into masonry.

This Standard specifies requirements for wall ties for use in tying together the leaves of cavity masonry walls, masonry veneer walls and loadbearing frames, and masonry veneer walls against a strong backing wall.

Specifies minimum requirements for the design and construction of unreinforced, reinforced and prestressed masonry, including built-in components.

Specifies requirements for construction practices for masonry in buildings of Class 1 and Class 10a, as defined in the National Construction Code (NCC), designed in accordance with AS 4773.1 and to be constructed from clay, concrete, or calcium silicate masonry units.

This document specifies requirements for the design and installation of sanitary plumbing and drainage from fixtures to a sewer, common effluent system or an on-site wastewater management system. It applies to new installations as well as alterations, additions or repairs to existing installations. It does not apply to the pre-treatment of trade wastes.

AS NZS 3000 2018 (known as the Australian/New Zealand Wiring Rules) specifies requirements for the design, construction and verification of electrical installations, including the selection and installation of electrical equipment forming part of such electrical installations; part 1 provides provisions that constitute the minimum regulatory requirements for a safe electrical installation; part 2 provides work methods and installation practices that are ‘deemed to comply’ with the requirements of Part 1.

AS/NZS 5263.0:2023 specifies general requirements and test methods for appliances and equipment which use gas as a fuel and which are intended for domestic, commercial or light industrial use, to an energy input limit of 1 000 MJ/h or any lower limit specified in the appliance-specific part of the AS/NZS 5263 series of Standards. Provides requirements for appliances for fixed installation, portable and mobile appliances and appliances for use in caravans and boats

AS/NZS 2658 specifies general requirements and test methods for portable and mobile appliances which use vaporized LP Gas as a fuel. The gas pressure at the injector orifice may be regulated or at vapour pressure.

This Standard applies to single-phase or polyphase, air-cooled (natural or forced) portable inverters having a rated supply voltage not exceeding 60 V ripple-free d.c. and an alternating current (a.c.) output where: - the rated output does not exceed 3 kVA; - the rated output voltage is within the range 50 - 500 volt a.c; - the rated frequency of the output is within the range 40 - 100 Hz.