Search all content

971 - 980 of 2327 results
AS/NZS 2350.1:2006 Methods of testing portland, blended and masonry cements, Method 1: Sampling 2006 cover

Standards Australia/Standards New Zealand

Version:  Second Edition 2006.  (Current)
Describes methods and provisions to be complied with for taking samples of cement representative of given lots for testing to assess the quality of products prior to, during or after delivery.
AS 2345-2006 Dezincification resistance of copper alloys 2006 cover

Standards Australia

Version:  Third Edition 2006.  (Current)
Specifies procedures for determining the resistance of copper-base alloys containing zinc dezincification.
AS 4458-1997 Pressure equipment - Manufacture 1997 cover

Standards Australia

Version:  First Edition 1997.  (Current)
Sets out requirements for the manufacture of pressure equipment as specified in the application Standards AS 1210, AS 1228 and AS 4041. Fabrication, heat treatment, forged construction, cast construction and testing are covered.
AS/NZS 2098.1:2006 Methods of test for veneer and plywood, Method 1: Moisture content of veneer and plywood 2006 cover

Standards Australia/Standards New Zealand

Version:  Second Edition 2006.  (Current)
This Standard sets out two methods for determining the moisture content of veneer and plywood; Oven-dry method and Electrical resistance measuring method - provision is also made for other electrical methods.
AS 1830-2007 Grey cast iron 2007 cover

Standards Australia

Version:  Fourth Edition 2007.  (Current)
Adopts ISO 185:2005 to specify properties of unalloyed and low-alloyed grey cast irons used for castings, which have been manufactured in sand moulds or in moulds with comparable thermal behaviour.
AS/NZS 4347.0:1995 Damp-proof courses and flashings - Methods of test, Part 0: General introduction, list of methods and test specimen requirements 1995 cover

Standards Australia/Standards New Zealand

Version:  First Edition 1995.  (Current)
This Standard specifies the requirements for the quantity and size of the test specimens required in the AS/NZS 4347 suite of Standards.
AS 1012.2:2014 Methods of testing concrete, Method 2: Preparing concrete mixes in the laboratory 2014 cover

Standards Australia

Version:  Fourth Edition 2014.  (Current)
This Standard sets out a method for the preparation of concrete mixes in the laboratory.
AS 2350.2-2006 Methods of testing portland, blended and masonry cements, Method 2: Chemical composition 2006 cover

Standards Australia

Version:  Third Edition 2006.  (Current)
This Standard sets out the method for determining, by proven chemical methods, the required composition of cement.
AS 4120-1994 Code of tendering 1994 cover

Standards Australia

Version:  Second Edition 1994.  (Current)
Sets out the ethics and obligations of the principal and tenderers in the tendering process in the construction industry. It applies to the selection of contractors and subcontractors. Published in conjunction with the Construction Industry Development Agency.
AS/NZS 2111.1:1996 Textile floor coverings - Tests and measurements, Method 1: Machine-made textile floor coverings - Determination of total thickness 1996 cover

Standards Australia/Standards New Zealand

Version:  Second Edition 1996.  (Current)
Identical adoption of ISO 1765:1986, this standard specifies a basic method for the determination of the thickness of machine-made textile floor coverings. Where areas of different thickness or construction exist, these should be tested separately if possible.