Search all content

​This Standard specifies test methods for the energy performance of incandescent lamps, both tungsten filament and tungsten halogen, that are used in general lighting service.

This Standard sets out the method of determining the water permeability of damp-proof courses and flashings.

This Standard describes the procedure for determining the mass per unit area of surface pile, which can be cut from above the substrate of a textile floor covering. The surface pile mass per unit area can be expressed at its equilibrium condition or in terms of clean conditioned mass at agreed commercial allowances.

Sets out the method for determining the relative quantity and rate that mixing water will bleed from a sample of freshly mixed concrete under the conditions of the test.

Specifies a spectrophotometric method using reduced ß-silicomolybdate complex, for the determination of the total silicon content of iron and steel. The method covers the range 0.005 percent to 5.0 percent silicon and is applicable to all grades of iron and steel.

Sets out methods for the sampling, preparation of samples and analysis of dolomite and magnesite refractories and refractory materials.

Provides guidance on the siting and construction of new buildings against aircraft noise intrusion and on the acoustical adequacy of existing buildings in areas near aerodromes. The assessment of potential aircraft noise exposure at a given site is based on the Australian Noise Exposure Forecast (ANEF) system. The Standard also provides guidelines for determining the type of building construction necessary to provide a given noise reduction.

Sets out requirements for the manufacture of pressure equipment as specified in the application Standards AS 1210, AS 1228 and AS 4041. Fabrication, heat treatment, forged construction, cast construction and testing are covered.

This Standard sets out a method for the preparation of concrete mixes in the laboratory.

This Standard sets out two methods for determining the moisture content of veneer and plywood; Oven-dry method and Electrical resistance measuring method - provision is also made for other electrical methods.