Search all content

Specifies domestic washing and drying procedures for textile testing; procedures are applicable to textile fabrics, garments or other textile articles which are subjected to appropriate combinations of domestic washing and drying procedures.

Sets out the procedure for determining the resistance of a soil to penetration by a flat ended rod of 16 ±0.2 mm diameter driven with a 9 kg mass, dropping 600 mm; use of the method is limited to granular soils with a maximum particle size not exceeding 2 mm, and a layer thickness of at least of 450 mm.

States the level of fire propagation acceptable for the use-surface of any textile floor covering when ignited using a small ignition source. The methenamine tablet used for the test is specified in AS 2111.18.

Adopts ISO 10545-6:2010, which specifies a test method for determining the resistance to deep abrasion of all unglazed ceramic tiles used for floor coverings.

Specifies requirements for the manufacture, grading and finishing of plywood intended for marine use.

Adopts IEC61439-4, Ed. 1.0 (2012) to provide specific requirements for the design of low-voltage switchgear and controlgear assemblies for use on construction sites.

AS 3786:2022 adopts and modifies ISO 12239:2021 for Australia which specifies requirements, test methods, performance criteria, and manufacturer’s instructions for smoke alarms that operate using scattered light, transmitted light, or ionization, and are intended for household or similar residential applications.

The objective of AS/NZS 3820:2020 is to provide a set of criteria for the safety of electrical equipment before being placed on the market. For electrical equipment that is required to be approved/certified/registered by electrical safety legislation before being placed on the market, there are specific regulatory requirements additional to the requirements given in this Standard.

This Standard sets out requirements for the design, installation and commissioning of special hazards detection, actuation and control systems comprising components complying with the requirements of the relevant product Standards itemized in AS1670.1.

Specifies an infrared absorption method after combustion of the test portion at high temperature in a current of pure oxygen using a high frequency induction furnace. The method can be used for the determination of sulfur content between 0.002 percent and 0.10 percent in steel. This Standard is identical with and reproduced from ISO 4935:1989.