Search all content

Specifies the requirements for the production and supply of cold-formed, electric resistance-welded, steel hollow sections used for structural purposes. It considers three strength grades, with or without impact properties, that are suitable for welding.

This Standard specifies requirements for the design, construction, performance and testing of emergency luminaires and exit signs. It applies both to emergency luminaires and exit signs that are centrally supplied, and to emergency luminaires and exit signs of the selfcontained type.

Specifies performance requirements for prepainted and organic film/metal laminate products in sheet and strip form that are coated on one or both sides with an organic film, and that are intended for fabrication into products for use in the construction or finishing of buildings.

This Standard specifies a method for the determination of the thickness of pile above the substrate of a textile floor covering. It is applicable to all textile floor coverings with pile capable of being shorn from the substrate, but not to textile floor coverings of varying pile thickness or density, unless the areas can be measured separately.

This Standard specifies requirements for protective headgear for vehicle users, designed to mitigate the adverse effect of a blow to the head. The Standard is written with particular reference to motor cyclists, but is also applicable to users of other types of motor vehicles. Marking requirements and instructions for use and care are also included.

This Standard sets out the method of determining the impact resistance of flat sheet material.

Serves as a general introduction to the AS/NZS 1158 series and provides definitions of lighting categories and technical terms essential to the understanding of other Standards in the series especially AS/NZS 1158.1.1, 1158.2, 1158.3.1 and 1158.6.

This Standard deals with the safety of electric thermal-storage room heaters for household and similar purposes that are intended to heat the room in which they are located, their rated voltage being not more than 250 volt for single-phase appliances and 480 volt for other appliances

This Standard describes a method for measuring the thickness, compression and recovery characteristics of textile floor coverings.

Presents the objectives and principles of adaptable housing and provides guidelines on planning and design. Adaptable housing is the basis for the development of the accommodation needs of users of all ages and abilities by making provision for future building modifications at minimum cost and disruption to the inhabitants. Includes in Appendix A a checklist for certification of housing units as Adaptable house class A, B or C.