Search all content

1 - 10 of 81 results
Western Australia Guide to standards and tolerances 2019 2019 cover

Western Australia Government

Version:  2019.  (Current)
The Western Australia guide to standards and tolerances 2019 (the Guide) has been developed for use by builders and building owners as a convenient reference for acceptable standards of workmanship in residential building construction; it is intended to address areas that are not prescribed under legislation or under a home building contract.
Building permits and other exemptions BP-02 | Amending a building permit 2023 cover

Victorian Building Authority

Version:  2023.  (Current)
This Practice Note provides guidance for building surveyors for amending a building permit in compliance with the Building Act 1993 and the Building Regulations 2018.
Technical qualifications for licensing: Queensland Building and Construction Commission licence requirements (QLD) 2021 cover

Queensland Government

Version:  2021.  (Current)
Sets out the technical qualifications required for each class of licence under Schedules 2, 3 and 3A of the QBCC Regulation.
Mutual Recognition: Application Form (QLD) cover 2022

Queensland Building And Construction Commission

Version:  2022.  (Current)
Applicants from: Australian Capital Territory, New South Wales, Northern Territory, South Australia, Tasmania, Victoria, Western Australia and New Zealand can use this form.
Licence Application Form - Individual. For All Builder, Hydraulic Design And Building Design Licence Classes (QLD) 2021 cover

Queensland Building And Construction Commission

Version:  2021.  (Current)
You are not able to apply for a licence if you are not a citizen, permanent resident or do not have a current Australian work visa.
Builder And Designer Experience Form - For All Builder, Hydraulic Design And Building Design Licence Classes (QLD) 2020 cover

Queensland Building And Construction Commission

Version:  2020.  (Current)
Builder And Designer Experience Form.
AS/NZS 5139:2019 Electrical installations - Safety of battery systems for use with power conversion equipment 2019 cover

Standards Australia/Standards New Zealand

Version:  First Edition 2019.  (Current)
Specifies requirements for general installation and safety requirements for battery energy storage systems (BESSs), where the battery system is installed in a location, such as a dedicated enclosure or room, and is connected with power conversion equipment (PCE) to supply electric power to other parts of an electrical installation.
AS/NZS 5033:2021 Installation and safety requirements for photovoltaic (PV) arrays 2021 cover

Standards Australia/Standards New Zealand

Version:  Fourth Edition 2021.  (Current)
Sets out general installation and safety requirements for electrical installations of PV arrays, including d.c. array wiring, electrical protection devices, switching and earthing provisions.
AS/NZS 3008.1.1:2017 Electrical installations - Selection of cables, Part 1.1: Cables for alternating voltages up to and including 0.6/1 kV - Typical Australian installation conditions 2017 cover

Standards Australia/Standards New Zealand

Version:  Third Edition 2017.  (Pending Revision)
Sets out a method for cable selection for those types of electrical cables and methods of installation that are in common use at working voltages up to and including 0.6/1 kV at 50 Hz a.c.
AS/NZS 4509.2:2010 Stand-alone power systems, Part 2: System design 2010 cover

Standards Australia/Standards New Zealand

Version:  First Edition 2010.  (Pending Revision)
Provides requirements and guidance for the design of stand-alone power systems with energy storage at extra-low voltage and used for the supply of extra-low and/or low voltage electric power in a domestic situation.