Search all content

This Act is the Plumbing and Drainage Act 2011. (NSW legislation.)

This Regulation is the Plumbing and Drainage Regulation 2017.(NSW legislation.)

Authorised Version incorporating amendments as at 1 February 2024. (VIC legislation.)

This Act may be cited as the Plumbing and Drainage Act 2018. (QLD legislation.)

AS NZS 3000 2018 (known as the Australian/New Zealand Wiring Rules) specifies requirements for the design, construction and verification of electrical installations, including the selection and installation of electrical equipment forming part of such electrical installations; part 1 provides provisions that constitute the minimum regulatory requirements for a safe electrical installation; part 2 provides work methods and installation practices that are ‘deemed to comply’ with the requirements of Part 1.

AS/NZS 5263.0:2023 specifies general requirements and test methods for appliances and equipment which use gas as a fuel and which are intended for domestic, commercial or light industrial use, to an energy input limit of 1 000 MJ/h or any lower limit specified in the appliance-specific part of the AS/NZS 5263 series of Standards. Provides requirements for appliances for fixed installation, portable and mobile appliances and appliances for use in caravans and boats

AS/NZS 2658 specifies general requirements and test methods for portable and mobile appliances which use vaporized LP Gas as a fuel. The gas pressure at the injector orifice may be regulated or at vapour pressure.

AS/NZS 1547:2012 provides the requirements for treatment units and their respective land application systems to achieve sustainable and effective on-site domestic wastewater management, to protect public health and the environment. This Standard identifies the performance statements that cover the overall design and sustainable management of on-site domestic wastewater systems.

This Standard applies to single-phase or polyphase, air-cooled (natural or forced) portable inverters having a rated supply voltage not exceeding 60 V ripple-free d.c. and an alternating current (a.c.) output where: - the rated output does not exceed 3 kVA; - the rated output voltage is within the range 50 - 500 volt a.c; - the rated frequency of the output is within the range 40 - 100 Hz.

AS/NZS 1158.1.1:2022 specifies performance and design requirements for Category V lighting schemes, including requirements relating to the energy efficiency of the luminaires used. It also specifies the luminaire data and other design data that is needed to facilitate the lighting design and the assessment  of conformance to the requirements of this document.