Search all content

Proposes requirements for the design, and test methods for, drive units, leaves and components of powered pedestrian doors, including constructions that are operated electro-mechanically, electro-hydraulically or pneumatically.

Specifies the test methods and conditions for self-ballasted compact fluorescent lamps (CFLs) and other gas-discharge lamps with integrated means for controlling starting and stable operation that are intended for domestic and similar general lighting purposes.

AS 1141.23:2021 sets out the procedure for the determination of the loss, on abrasion, of aggregate particles by means of the Los Angeles abrasion testing machine. The test is applied to aggregate particles from crushed rock, gravel or crushed slag, or to crushings derived from rock spalls or drill cores. The maximum particle size is between 53 mm and 9.5 mm.

This Standard specifies requirements and gives recommendations for the design and use of direction signs and related navigational aids including route numbering for all roads including expressway type roads.

AS/NZS 60335.2.40:2019 deals with the safety of electric heat pumps, including sanitary hot water heat pumps, air conditioners, and dehumidifiers incorporating motor-compressors and hydronic fan coils units, their maximum rated voltages being not more than 250 V for single phase appliances and 600 V for all other appliances. Partial units are within the scope of this Standard.

The objective of this Test Method is to specify a test method for determining the modulus of rupture and breaking strength of all ceramic tiles.

Specifies requirements for wrought aluminium and aluminium alloy flat sheet, coiled sheet and plate for general engineering purposes. Chemical composition, mechanical properties and allowable tolerances on dimensions are specified. An appendix provides information on typical fabrication characteristics and applications.

Specifies the loads and load combinations to be applied to the various components (e.g. studs, joists, etc.) of a metal frame for a domestic building up to two storeys in height and a roof pitch of up to 35 degrees. Requirements are also specified for the dynamic performance of floors.

Specifies requirements for perforated plastics pipe and associated fittings designed for use in the drainage of surface and subsurface land, highway and building construction sites.

AS 3499:2022 specifies requirements for flexible hose assemblies for use with both heated water and cold water supplies with a maximum heated water temperature of 90 °C used for applications above ground and accessible. Nominal sizes range up to DN 50, a maximum length of 10 m and with a working pressure not exceeding 1 400 kPa at 20 °C.