Search all content

Defines terms relating to textile floor coverings, components, substrates and maintenance. Also defines categories of textile floor coverings according to their structural composition.

AS 1141.3.1 defines requirements and specifies test methods for: taking samples of coarse and fine aggregates; subdividing samples; and packing and forwarding samples for examination and testing. Limited to aggregate and rock products with a nominal size of 75 mm or less. May be applied to non-stabilized soil product or soil and rock blends, provided that the maximum particle size is less than 75 mm

Adopts and modifies ISO 15818:2017, which specifies the performance requirements for the lifting and tying-down attachment points of earth-moving machinery as defined in ISO 6165. Applies to components and subassemblies of earth-moving machinery which the manufacturer intends to be lifted or tied down separately by using lifting or tying-down attachment points.

Specifies the construction, dimensions and test requirements for single- and multicore cables insulated with polymeric materials intended for use at working voltages up to and including 0.6/1 (1.2) kV. It does not apply to polymeric insulated cables for special installations and service conditions or for which there are separate Australian/New Zealand Standards.

Sets out requirements for the selection, identification, installation, finishing, and maintenance of timber and composite doors and doorsets for internal and external application.

Specifies product requirements for sawn and milled hardwood products. Moisture content, profiles, tolerances and grades are covered. Requirements are also given for glued laminating, finger jointing and end-matching. Guidance is given on information to be supplied when ordering.

This Standard describes the reference method for determining the fineness index of cement by the air permeability method, expressed in terms of surface area in square metres per kilogram of cement determined at a temperature of 23 ±2°C.

Specifies requirements for the safe use of tower cranes, covering planning, selection, siting, personnel, inspection, testing, erection, dismantling, personnel safety, operation, maintenance and repair. Appendices provide typical inspection and testing certificates as well as inspection testing check sheets.

The objective of this Standard is to set out the requirements for amorphous silica for use as a cementitious material in concrete, mortar and related applications.

This Standard sets out the method for determining the transverse strength of roof tiles after immersion in water for 24 h.