Search all content

The objective of this Standard is to specify performance requirements for duct sampling equipment for use in fire detection and alarm systems or smoke control systems conforming with the requirements of AS 1670.1, Automatic fire detection and alarm systems — System design, installation and Commissioning, Part 1: Fire.

AS 3499:2022 specifies requirements for flexible hose assemblies for use with both heated water and cold water supplies with a maximum heated water temperature of 90 °C used for applications above ground and accessible. Nominal sizes range up to DN 50, a maximum length of 10 m and with a working pressure not exceeding 1 400 kPa at 20 °C.

AS 4691.1:2023 specifies functional requirements for laser devices that are used to measure the speed of vehicles for purpose of, but not limited to, personal, industry, scientific and law enforcement.

Specifies requirements for wrought aluminium and aluminium alloy flat sheet, coiled sheet and plate for general engineering purposes. Chemical composition, mechanical properties and allowable tolerances on dimensions are specified. An appendix provides information on typical fabrication characteristics and applications.

Specifies the loads and load combinations to be applied to the various components (e.g. studs, joists, etc.) of a metal frame for a domestic building up to two storeys in height and a roof pitch of up to 35 degrees. Requirements are also specified for the dynamic performance of floors.

The objective of this Standard is to provide uniform requirements that regulatory authorities may apply in Australia for basic safety and public health issues relating to the use of water heaters and hot-water storage tanks.

Specifies the requirements for minimum energy performance standards, maximum wattage, and other requirements for tungsten filament, tungsten halogen and carbon filament incandescent lamps designed to produce a visible, optical radiationKEYWORDS: INCANDESCENT; LAMPS; MEPS; ENERGY; HALOGEN; EFFICIENCY

This Standard sets out a method for determining the indirect tensile strength of standard concrete cylinders, prepared in accordance with AS 1012.8.1.

Specifies device specifications, functionality, testing and compliance requirements for electrical safety and performance for inverters designed to facilitate connectivity between energy sources and/or energy storage systems and the grid, connected at low voltage. Includes electric vehicles operating in a vehicle to grid mode and stand-alone inverters that are connected to an electrical installation that may be connected to the grid at low voltage. KEYWORDS: inverter, energy storage, grid connection

This Standard sets out the method for determining moisture content, dry density and ambient density of masonry units, segmental pavers and flags.