Search all content

531 - 540 of 1762 results
AS 6669:2016 Plywood - Formwork 2016 cover

Standards Australia

Version:  Second Edition 2016.  (Current)
Specifies requirements for the manufacture, grading, finishing and branding of plywood used specifically in formwork, with a maximum length of 3100mm and width of 1500mm, intended to meet off-form surface finish requirements of Classes2, 3, 4 and 5 as specified in AS3610.1.
AS 2503.5-2003 Refractories and refractory materials - Chemical analysis, Part 5: Chrome-bearing materials 2003 cover

Standards Australia

Version:  Second Edition 2003.  (Current)
Sets out methods for the sampling, sample preparation, and analysis of chrome-bearing materials.
AS/NZS 4672.2:2007 Steel prestressing materials, Part 2: Testing requirements 2007 cover

Standards Australia/Standards New Zealand

Version:  Second Edition 2007.  (Pending Revision)
Specifies the minimum frequency of testing necessary to ensure compliance with the requirements of AS 4672.1 for prestressing steel products intended for use in concrete structures designed in accordance with AS 3600 or NZS 3101.1.
AS/NZS 2111.16:1996 Textile floor covering - Tests and measurements, Method 16: Determination of bond strength between backing components 1996 cover

Standards Australia/Standards New Zealand

Version:  First Edition 1996.  (Current)
This Standard describes a method for determining the strength of the bond between the backing components of a textile floor covering which can be peeled apart. This method is applicable to tufted carpets which have primary and secondary backing materials forming a bonded composite substrate.
AS/NZS 2350.16:2006 Methods of testing portland, blended and masonry cements, Method 16: Determination of air content of masonry cement 2006 cover

Standards Australia/Standards New Zealand

Version:  Second Edition 2006.  (Current)
This Standard sets out the method for determining the air content of a masonry cement prepared and tested as a standard mortar.
AS 2758.7:2015 Aggregates and rock for engineering purposes, Part 7: Railway ballast 2015 cover

Standards Australia

Version:  Second Edition 2015.  (Current)
Provides a basis for specifying requirements for aggregates intended for use as railway ballast.
AS 5100.8:2017 Bridge design, Part 8: Rehabilitation and strengthening of existing bridges 2017 cover

Standards Australia

Version:  First Edition 2017.  (Current)
Sets out requirements and procedures for the repair or rehabilitation, extension of remaining service life, strengthening to restore capacity due to structural deterioration, strengthening to increase capacity for live load, and changing the function of and widening of existing bridges.
AS 2428.6-2004 Methods of testing smoke/heat release vents, Method 6: Determination of ability to operate under snow loading 2004 cover

Standards Australia

Version:  Second Edition 2004.  (Current)
This Standard sets out the method for determining the ability of a smoke/heat release vent to operate when covered with snow.
AS/NZS 4347.4:1995 Damp-proof courses and flashings - Methods of test, Method 4: Determination of pliability - Materials with fabric or felt base 1995 cover

Standards Australia/Standards New Zealand

Version:  First Edition 1995.  (Current)
This Standard sets out the method of determining the pliability of damp-proof courses with fabric or felt base.
AS 2350.13-2006 Methods of testing portland, blended and masonry cements, Method 13: Determination of drying shrinkage of cement mortars 2006 cover

Standards Australia

Version:  Second Edition 2006.  (Current)
This Standard sets out the method for determining the drying shrinkage of cement mortars of defined composition.